Electronics Reverse Engineering in Kenya
When a board fails and no schematic, service manual, or manufacturer support exists, repair starts with understanding the circuit itself. Sinsal reverse-engineers legacy and undocumented electronics to the point needed for component-level repair — not to reproduce or resell a design.
Service Overview
Legacy and discontinued equipment often has no schematic and no vendor left to ask. Reverse engineering builds the technical understanding of a board's circuit that is needed to diagnose or repair it responsibly.
The output is usable documentation: a connection map, component identification, interface description and test points, and a partial schematic where that is achievable. Complete schematic reconstruction is not always possible and the scope is agreed before work begins.
Equipment We Work On
- Legacy control and instrument boards
- Discontinued OEM modules
- Boards from equipment whose vendor no longer exists
- Proprietary interface and adapter boards
- Boards needing a documented replacement strategy
Typical Failures
- Failure on a board with no documentation
- A discontinued part that needs an equivalent identified
- A fleet depending on one board with no spares
- A board that has been modified without records
Diagnostic Process
- 01Inspection and identification of components and layers where visible
- 02Tracing of power paths and key signal paths
- 03Identification of interfaces and test points
- 04Recording of findings in a usable form
Repair Process
- 01Documentation supports diagnosis and repair of the board
- 02It can also support a spares or substitution plan where appropriate
Testing and Validation
- Documented circuit sections are checked against measured behaviour
- Repairs based on the documentation are verified as usual
What You May Receive
Circuit understanding sufficient to support repair, Diagnostic findings, Repair record where work proceeds.
Warranty
Completed repairs are accompanied by warranty documentation. The cover, its term and its exclusions are written on the warranty document issued with the job, so they are agreed in writing for your equipment rather than assumed. Warranty applies to the repaired fault and the work carried out, not to unrelated failures elsewhere in the equipment.
Important Limitation
Reverse engineering here is scoped to understanding a circuit for repair purposes — it does not reproduce, redistribute, or claim ownership of the original manufacturer's design or intellectual property, and does not extend to full schematic capture unless specifically agreed.
Common Questions
Does Sinsal reverse-engineer a full schematic for every board?
Not always — the work is typically scoped to understanding the specific circuit area relevant to the fault, which is usually faster and sufficient for repair. Full schematic capture can be discussed if genuinely needed.
Is this legal for boards without manufacturer documentation?
Yes — reverse engineering an undocumented circuit for repair purposes is standard practice in independent electronics repair. It does not involve reproducing or reselling the manufacturer's intellectual property.
Have a Board Nobody Has Documentation For?
Describe the equipment and the fault. Sinsal will confirm whether it is a fit for diagnostics and repair before any work begins.
Already submitted equipment? Track your equipment